The body is made of pure brass RoHS compliant Which is Specialized for the hi-fi sound by Reducing; impurities Such as lead, iron, cadmium or Which May Cause Turbidity of sound.
The body, hole and taper angle are trimmed by NC machining Which is extremely accurate. And it Apply "half-bright chrome plating" on the body, it not only gives higher rigidity and durability of the surface of an INS-BS but also the beauty of the texture.
On one side of INS-BS, a carbon FRP board is attached for the stability of the contact surface and induction for vibration to the body. And, the CFRP board is 0.01mm projected upward from the body Which Enable to make only the board of the contact surface.
φ20 4mm deep concave in Which INS-CF can be set-in for Enhancing Signal-to-Noise ratio and altering the Timbre of the playback sound impression.
A hole for the screw mount is Placed on the center Which Enable attach the INS-BS Directly to the devices.
Attention: Please make sure That the insulator of the devices is attached by screw and detachable before trying attach INS-BS to your device. And since the length of the hole is 5mm, the Shorter than 5mm screws can not be used. In addition, please use a washer IF a screw head is smaller than concave. Screws and washers are not included in the package.
Body material- Pure brass (RoHS compliant)
Surface material- Carbon FRP
Dimentions- φ35.0x H15.0
Hole diameter φ5.0 mm
Concave- φ20mm x 4mm deep (for INS-CF)
Withstand load 200kg/pc
